Due to work experience and loss of time i had to make a few changes to the plan of this puppet. The main change is that i was plaining on...

He's Finally finished

For the boys hat i asked a friend to knit a bobble hat for me to place on his head. This was made two time as i had the dimensions wrong...

Next to paint he head i sprayed it with some matt paint. This did not turn out how i wanted. the over all colour was fine but for some...

When opening my mold it sadly broke leaving my figures stuck inside. However it should still work and allow me to cast some hand. Before...

With the wire made i sculpted an arm and hand over the wire in super sculpie. And attached it to my puppet to make sure the size was ok....

Next i build the boys arms using heat shrink covered wire and k&s. this was all stuck together with two part epoxy. I made sure to make...

to make my hands i twisted 2 strands of 0.5mm aluminum wire with 2 strands of 0.5mm cotton covered copper wire around a small washer. I...

When my armature arrived i realized that the arms where a little to so i decided to shorten one of the bars. This will allow me to attach...

With the shoes drying and casting i decided to start making the boys eyes. To do this i covered the head with clingfilm and sculpted some...

I then removed the shoes from the mold and cut off the excess silicone. I then repeated this process again so i had two shoes. The image...

For the little boys feet i also chose to use silicone as i believe this will give the nicest finish. For this process i followed exactly...

For my props i had a mixture of both 2D and 3D. For the 2D props Eirian helped me out and drew a flower vaise in two key frames, this...

yay!!!Cat is finished!!

Next i drilled 6 holes into the face and place some cotton covered copper wire in the holes. The reason i chose to use this wire is that...

Finally everything is coming together. With the fur added and the legs cast. So next i painted the face and added fur to the ears. so far...

In my original plan my cat puppet was meant to have replacement faces, so i sculpted the nose an moth area and decided to make a mold....

To create my eye balls i found a bead the size i needed. However this bead was purl when i needed it to be white. To fix this i decided...